Cisco Firepower 9300 Command Reference

Mode PromptCommands Used to AccessMode Name
/host-eth-if #scope host-eth-if command from EXEC
mode
This command and all
subcommands are not supported
at this level; the Host Ethernet
interface commands are available
in /adapter # mode.
Note
Host Ethernet interface
/license #scope license command from EXEC modeLicense
/monitoring #scope monitoring command from EXEC
mode
Monitoring
/org #scope org command from EXEC modeOrganization
/packet-capture #scope packet-capture command from
EXEC mode
Packet capture
/security #scope security command from EXEC modeSecurity
/server #scope server command from EXEC modeServer
/service-profile #scope service-profile command from EXEC
mode
Do not alter or configure service
profiles; that is, do not use the
create, set, or delete
subcommand sets.
Note
Service profile
/ssa #scope ssa command from EXEC modeSSA
/system #scope system command from EXEC modeSystem
/vhba #scope vhba command from EXEC mode
This command and all
subcommands are currently not
supported.
Note
Virtual HBA
/vnic #scope vnic command from EXEC modeVirtual NIC
Cisco Firepower 4100/9300 FXOS Command Reference
6
CLI Overview
Command Modes

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes