4-58 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Setup Menu: Outputs: TS Out: DPM, Continued
Global
Resync All:
Description: This resynchronizes all DPM output with the PMT data for all
program entries.
Parameters: ASI or MOIP1.
Copy:
Description: This copies all DPM data from either the ASI output to the MOIPI
output (MPEG over IP) or from the MOIPI output to the ASI output
depending on your selection.
Parameters: ASI->MOIPI or MOIPI->ASI.
ASI/MOIP1
PE
Description: This selects the DPM Program Entry to view/modify.
Parameters: 1. Default is 1.
InCh
Description: Displays the input channel of the current PE.
Parameters: 1 to 65535.
PMT
Description: This is the input PMT. This value is only to map to the output PMT
if the PE Action is set to MAP.
Parameters: 1 to 8192.
Act
Description: Selects the DPM action for the PMT associated with the PE.
Parameters: Pass, Drop, Map or Xcode. The default is Pass.
Id
Description: Selects the transcoder when Act is set to XCode.
Parameters: 1 or 2.
OutCh
Description: This selects the DPM output channel you want to map to the input
channel (InCh). This value is only used if the PE Action is set to
MAP.
Parameters: 1 to 65535.
To Next Page
Loading...
Need help?
General