Cisco PowerVu D9858 - Page 111

4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4-59
Setup Menu: Outputs: TS Out: DPM, Continued
PMT
Description: This is the DPM output PMT/service ID, which is the same as the
input PMT if it is present. the This value is only used if the PE
Action is set to Map.
Parameters: 1 to 65535.
PID (Press Select to view this level)
InType
Description: This indicates the input program stream category/service type. This
value is read-only.
In
Description: This indicates the stream instance. This value is read-only.
Parameters: 1 to 64.
PID
Description: This indicates the input program PID. This value is read-only. It is
only used if the PID Action is set to Map.
Parameters: 1 to 8190.
Act
Description: This selects the DPM action for the PID associated with the PE.
Parameters: Pass, Drop or Map.
OutType
Description: This selects the output program stream category/service type. This
value is only used if the PID Action is set to MAP.
Parameters: UNKN, CDT, LSDT, DATA, TTX, MPE, DPI, VBI, SUBT, AUD, VID,
PCR or INVL.
In
Description: This selects the output stream instance.
Parameters: 1 to 64.
PID
Description: This selects the output program PID.
Parameters: 1 to 8192.
Map Mode
Description: This parameter selects the DPM map mode.