EasyManua.ls Logo

Cisco PowerVu D9858 - Page 131

Cisco PowerVu D9858
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4-79
Setup Menu: Noise Cutoff, Continued
Trnsprt LDPC (Low Density Parity Check) BER
Description: Sets how the transcoder reacts when the signal quality is severely
degraded when using DVB-S2 modulation. This allows you to set
the transport and audio bit error rate (BER) values for the
transcoder. The transcoder uses these noise values/settings as
limits during normal operation to determine whether to mute the
transport and/or audio in the event of a noisy signal, poor signal or
no signal condition.
Parameters: Cutoff - This is the upper limit for the transport BER setting. The
transport will be muted when the BER is above the Cutoff setting,
and un-muted (e.g., restored) when the BER falls below the Restore
setting for a preset period of time. The adjustable operating range is
from 1.0e-9 (1.0x10-9) to 9.99e-1. The default setting for Transport
(LDPC BER) Cutoff is 1.4.e-2.
Restore - This is the lower limit for the transport BER setting. The
transport will be muted when the BER is above the Cutoff setting,
and un-muted (e.g., restored) when the BER falls below the Restore
setting for a preset period of time. The adjustable operating range is
from 1.0e-9 (1.0x10-9) to 9.99e-1. The default setting for Transport
(LDPC BER) Restore is 1.30e-2.
Note: Muting Control must be set to Enable for these settings to be
active.
Transport Default LDPC BER Relationship

Table of Contents