4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 5-15
FPGATemperature
Warning
Set Temperature over
Warning threshold
Cause: Room temperature
too high, or air flow is
blocked.
Remedy: Check openings
on front and rear panels for
blockage. Lower room
temperature or improve air
flow to device.
FPGA temperature is
above normal
operating range.
Clear Clear Temperature
Warning
TDT timeout Set tdt timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
problem persists determine
if uplink is sending the
current SI information
table. Disable the warning
if not using the table.
Time Date Table was
never received.
tdt is lost No longer receiving
Time Date.
Clear tdt fault cleared
SDT timeout Set sdt # timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
problem persists determine
if uplink is sending the
current SI information
table. Disable the warning
if not using the table.
Service Description
Table was never
received.
sdt # is lost No longer receiving
Service Description.
Clear sdt fault cleared
PMT timeout Set pmt # timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
problem persists determine
if uplink is sending the
current SI information
table. Disable the warning
if not using the table.
Program Mapping
Table was never
received.
pmt # is lost No longer receiving
Program Mapping
Table.
Clear pmt fault cleared
Warning Message
Type
Message Cause/Remedy Description
To Next Page
Loading...
Need help?
General