5-14 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Transport ErrorSet Set Continuity Count
Error
Cause: Possible uplink or
signal issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
Transport packet
continuity count
jumped. Possible
packet loss.
Buffer Overflow The transport stream
is faster than the
maximum buffer or
the decode engines
are having difficulty
handling the data
sent to them.
Transport Error
Indicator
Transport packets are
marked as "errored"
upstream of the
decoder.
Transport Rate Error:
FPGA Overflow
Cause: Uplink settings may
have changed since setting
up the unit. Variable Bit
Rate/Statmuxed streams
may be in use.
Remedy: Increase output
rate, drop unreferenced
content in DPM Options,
drop programs not needed
for downstream devices.
Contact uplink to verify
expected bitrate settings.
The output rate is
higher than level set
by the user.
Clear Continuity Count
Error ClearedClear
Trap expires after 30
seconds.
Buffer Overflow
Cleared
Transport Error
Indicator Cleared
Transport Rate Error:
FPGA Overflow
Cleared
Video Format
Mismatch
Video Format
Mismatch
Temperature
Warning
Set Temperature over
Warning threshold
Cause: Room temperature
too high, or air flow is
blocked.
Remedy: Check openings
on front and rear panels for
blockage. Lower the room
temperature or improve air
flow to device.
Temperature is above
normal operating
range.
Clear Clear Temperature
Warning
Warning Message
Type
Message Cause/Remedy Description
To Next Page
Loading...
Need help?
General