4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 5-13
Messages, Continued
Warnings
The following table shows an alphabetical list of the available messages and their
default warning status.
Warning Message
Type
Message Cause/Remedy Description
Transport Overflow Set ASI Output Overflow Cause: Uplink settings may
have changed since setting
up the unit. The Variable
Bit Rate/Statmuxed
streams may be in use.
Remedy: Increase output
rate, drop unreferenced
content in DPM Options,
and drop the programs that
are not needed for
downstream devices.
Contact your service
provider (uplink) to verify
expected bitrate settings.
The output rate is
higher than level set
by the user.
MPEGoIP Output
Overflow
Clear ASI Output Overflow
Cleared
MPEGoIP Output
Overflow Cleared
To Next Page
Loading...
Need help?
General