4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4-23
Setup Menu: Admin, Continued
Lock Level
Description: Sets the front panel keypad lock level.
Parameters: 0, 1, 2, 3 or 4.
Changing the Password
To change the password, enter the old password (Old Pwd). Next,
enter the new password (New Pwd, four digits in the range from
0000 to 9999) and re-enter the new password for confirmation
(Confirm Pwd). To change the password, the transcoder must be in
Lock Level 0. The default password is 1234.
Factory Reset
Description Select this option to perform a reset of transcoder settings back to
the factory set (default) values. A warning message prompts you to
confirm the operation.
Parameters: Reboot Unit - you are prompted to verify the operation.
Abort or Continue.
Clear FWD tables
Description Select this option to Clear the Forward Tables, which removes
stored database information applicable to upgraded software
versions. A warning message prompts you to confirm the
operation.
Parameters: Abort or Continue.
Reboot
Description: Allows you to reboot the transcoder. You will be asked to confirm
the operation.
Parameters: Abort or Continue. Select Continue to reboot the
transcoder or Abort to cancel the operation.
KB Lock
Description Sets the front panel keypad lock state.
Parameters: Enabled or Disabled.
KB Lock Timeout
Description: Sets the keypad lock timeout period. The lock timeout period takes
effect when the keypad has not been touched (i.e., a key has not
been pressed) when on the Main Menu for the set period. Avoid
setting the period to a short duration when the keypad is used
often.
Parameters: 5 to 1800 seconds. The default is 60 seconds.
To Next Page
Loading...
Need help?
General