UNITY INSTALLATION GUIDE
72
Installing Unity and
Continued
ActiveFax
To install Unity and ActiveFax on the Unity server
Do the following procedure to:
◆
Install Unity.
◆
Install ActiveFax on the Unity server or, if ActiveFax was
installed on a separate server, install the Exchange gateway
for ActiveFax on the Unity server.
Install ActiveFax on the Unity server only if you are configuring
the Unity server as a stand-alone voice messaging server with
LAN administration or as a unified messaging server in an exist-
ing Exchange site. Other configurations are not supported.
a Confirm that the Unity system key is connected to the Unity
server.
b Confirm that all voice and fax boards have been installed
and set up according to the “Hardware settings” instruc-
tions for your boards in Appendix A.
If you are installing a component system and the server
contains Dialogic D/41D voice boards, note the setting of
jumper JP1 (IRQ setting) because you must enter that value
at the end of the Setup program.
c Start the Unity server.
d Log on to Windows NT/2000 by using the account you chose
to use for installation.
e Insert Unity Disc 1 in the CD-ROM drive.
f Browse to the root directory of the Unity compact disc, and
run Setup.exe.
g Choose the language in which you want to view Setup
prompts, and click “OK.” A welcome message appears.
h Click “Next,” and Setup examines your system to confirm
that the required software is installed and configured prop-
erly, and that a system key is installed.
If an error message appears, correct the specified problem,
then rerun Setup.
i Follow the on-screen prompts.