Installing machine on workpiece
Page 28 CM6200 Operating Manual
8. Mount the machine to the
workpiece using setup
fingers (Figure 3-8).
9. Connect any control
cables that may be neces-
sary (depending on con-
figuration).
10. Check that the machine is
centered and leveled
before performing any
machining operations.
Horizontal to vertical lifting
When lifting the CM6200 from horizontal to vertical position, make sure that the
load tested lifting assembly (Figure 3-9) is correctly installed on the machine, as
described in Section 3.8.3 on page 41 and Section 3.8.4 on page 42.
This lifting device will keep the
machine stable and perpendicular,
making it safer and easier to lift the
machine vertically.
FIGURE 3-9. LOAD TESTED LIFTING ASSEMBLY P/N 68425
To Next Page
Loading...