RFDS and Telstra services
10-14 Outback HF Radiophone
Transmitting a Telstra (OTC) tone call
The tone call facility allows you to call a Telstra station using the transmission of a
simple signalling system–OTC tone call. It should be noted that whilst the tone call
facility is available it is recommended that, where ever possible, all calls to Telstra
are initiated by the selective call procedure—the preferred method of establishing
contact.
Before commencing this procedure, ensure the Voice Mute button is in the off
position (indicator off) and the antenna is tuned to the selected frequency.
The 'OTC Tone Call' button only operates on OTC designated channels.
Step Action… Display shows… Remarks…
1.
Use the channel
buttons or Select
Channel button to
select the OTC
(Telstra) channel
you wish to use.
2.
Ensure that the
channel is free
from traffic.
The display does not
change.
Listen for approximately
10 seconds.
3.
Press and hold
Tone Call
OTC
for approximately
10 seconds.
The display does not
change.
You will hear a tone and
the Tx indicator will be
lit.
4.
You can start communication when contact has
been established. It there is no response to
your call after two minutes, repeat steps 1–3 or
select another channel or Telstra station.
q