Making a telephone interconnect call
9-6 Outback HF Radiophone
Sending a disconnect message
When a telephone call is made, a circuit is automatically established between your
outstation Radiophone and the telephone party that the base IPC-500 has dialled.
When you finish a call, this call line must be disconnected. This is achieved by
sending a disconnect message from your Radiophone to the IPC-500.
This procedure assumes that the Radiophone is switched on and still on the original
channel, and the telephone conversation has been completed.
Step Action… Display shows… Remarks…
1.
Press
Call
Selective
This is an example for
the last called number
1234 on channel 1.
2.
Press
Enter
The last telephone
number you called was
08 336 0311.
3.
Press
Voice
Mute
This deletes the last
number.
4.
Press
Voice
Mute
You are now ready to
send the disconnect
message.
F
To Next Page
Loading...
Need help?
General
