Changing the set-up options
11-10 Outback HF Radiophone
Enter a PIN (Personal Identification Number)
If you select a PIN for the Radiophone, you will have to enter this PIN each time you
switch the Radiophone on. If you fail to enter the correct PIN, the Radiophone will
automatically switch off.
If a PIN code is set, the Radiophone can only be operated by entering the PIN.
It is important that every person who uses the Radiophone knows the PIN.
Alternatively, do not set the PIN code.
Should you forget the PIN, you will have to return the transceiver to the factory.
Step Action… Display shows… Remarks…
1.
Turn the
Radiophone off
and move the
control head link
from position E to
position 1.
No display. Refer to the procedure on
page 11-3.
2.
Hold down
1
Fast
and press
On/Off
Hold down the Tune Rx
Fast button until the
display shows
This switches your
Radiophone on and into
the PIN set-up mode.
3.
Use the numeric
buttons to enter
your PIN.
The display will show the
number you enter.
You can select a number
between 1 and 999999.
F
To Next Page
Loading...
Need help?
General
