Using selective call
5-6 Outback HF Radiophone
Setting the fixed called address
There are two ways of entering the called address:
a) as below, which is fixed and cannot be changed easily
b) by the method used on page 5.14, Transmitting a selective call (Open
access selective call) which allows the address to be entered from the front
panel of the control head and is easy to change to call another Radiophone or
transceiver.
Note: by setting a fixed called address the normal function of Selective Call
will change. If a fixed call address has been set, pressing Selective
Call will automatically send the programmed address. Open access
selective calling is disabled.
5.
Use the numeric
buttons to enter
the called address
number.
To delete an
address, enter four
zeros.
You can override an
existing address by
entering a new number.
6.
Press
Enter
Once Enter has been
pressed, the called
address has been set and
can only be changed by
repeating this procedure.
The next step must be
completed within 60
seconds.
F
Step Action… Display shows… Remarks…
Setting the self-identification address
To Next Page
Loading...
Need help?
General
