Using the receiver in scan mode
Outback HF Radiophone 6-7
Receiving in scan mode
This procedure covers three topics when receiving in scan mode. Ensure your
Radiophone is switched on before proceeding with any of the following:
• start scanning
• stop scanning
• changing the scan mode.
Start scanning
Step Action… Display shows… Remarks…
1.
Press
Scan
The display shows details
of each channel as it is
scanned.
The Scan button
indicator will be lit
during scanning.
Notes: You cannot transmit while the Radiophone is in the scan mode. If you
attempt to transmit, you will hear a single ’pip’ and the error message
’No Ptt Error’ will be displayed.
If you need to transmit, you must stop the scanning operation.
Stop scanning
Step Action… Display shows… Remarks…
1.
Press
Scan
or press the
microphone PTT
button twice in
succession.
The display shows the
last channel scanned.
The Scan button
indicator is off.
Note: If you only press the PTT button once, the display shows ’NO PTT Error’
To Next Page
Loading...
Need help?
General
