Making a telephone interconnect call
9-20 Outback HF Radiophone
Returning a call
This procedure explains how to return a telephone call to one of the numbers recorded
in the memory stack.
Ensure your Radiophone is switched on before commencing this operation.
Ensure the antenna is tuned on the selected channel, refer to Tuning the antenna in
section 4.
A permanent or brief loss of power to your Radiophone will delete information
stored in the memory stack. Ensure you record or use all the information stored
in the memory stack before switching off the Radiophone.
Notes: If the Radiophone power is lost momentarily (such as during starting the
vehicle engine ), the call memory is retained but the telephone number is lost.
Switching the Radiophone off using the On/Off button deletes all calls
stored in the memory bank.
Before making a telephone call, it is often beneficial to make a beacon call to
assess the best channel to use. (Refer to Using the beacon feature in
section 5.)
When you have finished returning calls, you must disconnect the telephone
line. (Refer to Sending a disconnect message on page 9-6).
Step Action… Display shows… Remarks…
1.
Select the call you
wish to make (see
Reviewing the list
of received calls
in memory on
page 9-18, steps 1
& 2).
This display example
shows the phone number
08 336 0311 and the self
identification address
1234 of the caller.
F
To Next Page
Loading...
Need help?
General
