Codan 8525B Series - (99) beacon mode

Using selective call
Outback HF Radiophone 5-29
(99) beacon mode
Step Action… Display shows… Remarks…
1.
Ensure your
Radiophone is
switched on.
The last channel selected.
2.
Select the
required test
channel and tune
the antenna.
Refer to section 4,
Selecting channels.
3.
Press
Call
Selective
When this button is
pressed, the S’Call Mute
is automatically switched
off.
4.
Use the numeric
buttons to enter
the required
selective call
number. Use the
first two digits of
the stations self
identification
number and
ensure the last two
are 99.
This will send a signal to
the base station enabled
for beacon call, whose
four digit self ident
address begins with 13.
F