Using the receiver in scan mode
Outback HF Radiophone 6-3
Setting up the scan mode
The scan program allows your Radiophone to scan a selected number of frequencies.
Your Radiophone also has the option to run in normal or Auto-scan mode. The Auto-
scan mode automatically puts the Radiophone back into scan after five minutes of
inactivity (such as no channel change, PTT, tune etc.). These scan facilities have two
options:
• Enabled—scan programs can be entered and deleted from the control head front
panel.
• Inhibit—scan programs cannot be entered or deleted from the control head front
panel.
Step Action… Display shows… Remarks…
1.
Ensure your
Radiophone is
switched off.
2.
Hold down
Scan
and press
On/Off
Hold down the Scan
button until the display
shows
This turns the
Radiophone on, and into
the scan set-up mode.
3.
Press
Scan
Each press of the Scan
button scrolls to the next
option.
If this is the option you
want, go to step 7.
F
To Next Page
Loading...
Need help?
General
