Display messages
Outback HF Radiophone 12-3
No. of ’beeps’ Message displayed Meaning
1
An attempt has been made to transmit
on a receive-only channel, or while
the scan mode is selected.
If the Radiophone is scanning, press
the Scan button to stop scanning. If
the channel selected is a receive-only
channel, select another channel.
1
An attempt has been made to select
the scan mode while the Radiophone
is transmitting, or no channels have
been entered in the scan program.
Check that the program has scan
channels, if not select another
program.
1
An attempt has been made to
program a receive frequency higher
than 30,000 kHz or a tone frequency
higher than 2800 Hz.
1
An attempt has been made to
program a channel with a frequency
lower than 250 kHz or a tone
frequency of 300 Hz or lower.
0
All 99 P-channels are programmed.
F
To Next Page
Loading...
Need help?
General
