Software
Copyright © 2015 Coda Octopus Products Ltd
112
F180R MOTION Sensor User and Reference Guide
On completion of the Configuration Wizard, you will have an option to save the configuration
settings on to your PC hard disk. These can then be uploaded to the F180R System at a later
date of your choice. Using this method you could save several system configurations and load
them for the appropriate setup.
5.3.15 Finish
Figure 94: MOTION Settings Wizard - Finish
The configuration wizard and the configuration will be saved as the last Settings that can be
accessed from the Introduction page.
5.4
Motion Data
Select Motion Data on the Home tab to display the real-time data chart. The title bar of the
chart will change depending on what additional parameters are set to define the output
location of the F180R System measurement and also the mode of MOTION Control, real-time
or playback.
"Real-Time Data or Playback Data: Lever Arm Motion"
when the remote lever arm values are applied
"Real-Time Data or Playback Data: Vessel Motion"
when only the vessel orientation is applied
"Real-Time Data or Playback Data : IMU Motion"
when no vessel orientation or remote lever arm settings are applied.
To Next Page
Loading...