CodaOctopus F180R - Changing the IP Address

To Next Page

To Previous Page

Appendices

147

F180R MOTION Sensor User and Reference Guide

Pinging 195.0.0.180 with 32 bytes of data:

Request timed out.

Ping statistics for 195.0.0.180 :

Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

NOTE: The ping may be blocked on some PCs with Windows Vista/7 if User Account

Control (UAC) is enabled.

3. If you have established a successful connection you can now connect and configure the

F180R System using MOTION Control. If you are unable to establish an active connection re–

check:

Network configuration.

F180R System IP address

PC IP address

Physical connection & cables

disable User Account Control (UAC) on Windows Vista/7

turn off the Windows Firewall or third party firewalls

turn off anti virus

4. When experiencing problems with ethernet MCOM data transmissions from either the

F180R System or MOTION Control it is possible to analyse the network traffic with a 3rd

party network traffic logger such as Ethereal. The UDP messages logged by Ethereal might

provide important information when seeking out network related errors.

6.4.2.4 Changing the IP Address

By default, the F180R System IP address is 195.0.0.180 with subnet 255.255.255.0. Initially, the

PC should be configured with a compatible IP address and subnet mask. If there is a

subsequent requirement to change the F180R System address then you can do so after making

the initial connection to the F180R System on the 195.0.0.xxx network address.

NOTE: The F180R System IP address can only be changed by first making connection on

the systems default network address.

This may be a requirement if the F180R System needs to be deployed on an existing network

on the vessel.