Appendices
Copyright © 2015 Coda Octopus Products Ltd
144
F180R MOTION Sensor User and Reference Guide
6.4.2.1 Physical Connection
The F180R System and the PC can be connected using :
A cross–over CAT5 Ethernet cable can be plugged into the PC
OR
An Ethernet hub or switch using standard CAT5 Ethernet cables.
It is usual for PC and laptop networks to have an LED that will light only when a valid network
connection is plugged in. If this LED fails to light when you plug in your network cable, it may
be a sign that a crossover connector is required.
6.4.2.2 PC LAN Connection
Follow the steps below to configure a connection between the PC and the local area network
(LAN).
1. On your Windows XP choose Start > Control Panel > Network Connections / for Windows 7
choose Start > Control Panel > View network status and tasks > choose the connection you use
Figure 110: Network Connection Status
2. Select the LAN connection that you wish to configure. Click Properties to display the
network connection properties.
To Next Page
Loading...