CodaOctopus F180R - System Warranty Information; System Calibration Recommendation

To Next Page

To Previous Page

Introduction

F180R MOTION Sensor User and Reference Guide

2.2

Warranty

Coda Octopus Products Ltd warrants the F180R System Inertial Attitude and Positioning System

to be free of defects in materials or workmanship for one year. The warranty period begins on

the date when the equipment was shipped from CodaOctopus or from their authorised

distributor.

NOTE: To ship the units between installation sites or to return them to CodaOctopus

for repair, package them with care. You should retain the original transit packing cases

for this purpose. The use of improper packing for shipping any part of this equipment

will invalidate the warranty.

For information concerning the proper return location and procedure, contact CodaOctopus or

their authorised distributor. The How To Get Support sections list contact details for

CodaOctopus. The responsibility of CodaOctopus in respect of this warranty is limited solely to

product replacement or product repair at an authorised location only. Determination of

replacement or repair will be made by CodaOctopus personnel or by personnel expressly

authorised by CodaOctopus for this purpose. This warranty will not extend to damage or

failure resulting from misuse, neglect, accident, alteration, abuse, improper installation, non-

approved cables or accessories, or operation in an environment other than that intended. A

'Shockwatch' label attached to the IMU casing will show a red central vial if the unit is

subjected to severe shock. If this occurs, contact CodaOctopus technical support for test

instructions.

The solid–state inertial measurement components are not field repairable.

NOTE: In no event will CodaOctopus be liable for any indirect, incidental, special or

consequential damages whether through tort, contract or otherwise. This warranty is

expressly in lieu of all other warranties, expressed or implied, including without

limitation the implied warranties of merchantability or fitness for a particular

purpose. The foregoing states the entire liability of CodaOctopus with respect to the

products described herein.

2.3

Calibration

We recommend to factory calibrate the F180R System hardware every 2 years to ensure

maximum accuracy. The calibration can't be performed in the field so please get in touch with

the CodaOctopus Support team to arrange a hardware calibration.