Software
Copyright © 2015 Coda Octopus Products Ltd
77
F180R MOTION Sensor User and Reference Guide
2. Select the check box to set Automatically Save RD file to
3. Select the browse icon and select the required data storage directory
4. Select OK to close the Raw Data Management interface
MOTION Control will then start transferring files from the F180R System to the host PC. This is
carried out as a background task. The system will transfer a file and then rest for a few
minutes. After the rest period it will start transferring the next file and so on until all the
selected files have been transferred. The Download Status will indicate if the the file has
been transferred or not.
Files can also be saved individually by highlighting the file entry in the listing and clicking the
Save button.
NOTE: The current active rd file which is still being written is not listed in the file
management dialog. This will only be added to the listing when it is closed.
Files are deleted by highlighting the file entry in the listing and pressing the Delete button.
Figure 58: Raw Data Management Dialog
5.2.1.1.1.2 Change IP Address
This option is used to change the IP address of theF180R System.
The default F180R System IP Address is 195.0.0.180 with subnet mask 255.255.255.0. However
the IP Address currently in us by the F180R System will be displayed in the Message Log area
when you connect to the system. Initially you will have to set your PC up with a compatible IP
Address and subnet. However, once you have established a valid connection to the F180R
System you may subsequently change these parameters if necessary.
To Next Page
Loading...