Right-Angle Configuration
Changing Orientation
Perform the following steps to change between in-line and right-angle configuration.
Note:
l Switching between in-line and right-angle configuration is recommended only up to 10 times in the lifetime
of your DataMan device.
l Disconnect the DataMan device from power before changing the orientation.
WARNING: Make sure that no electrostatic charges are applied to the PCB. (For example, wear ESD shoes.) If the
main module is separated from the I/O connector module, take care to assemble them correctly. Otherwise, the IP
rating can be compromised.
76
Mechanical Information
To Next Page
Loading...
