Compaq PORTABLE 386 - Page 37

retry limit. 5. Replace the system board and
retest.
1205 - 04 RCV exceeded carrier lost
limit.
1205 - 05 XMIT exceeded carrier lost
limit.
1205 - 06 Time out waiting for dial
tone.
1205 - 07 Dial number string too long.
1205 - 08 Modem timed out waiting for
remote response.
1205 - 09 Modem exceeded maximum
redial limit.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1205 - 10 Line quality prevented The following steps apply to error
remote connection. codes 1201 - 01 through 1210 - 11:
1205 - 11 Modem timed out waiting for 1. Check the jumper settings on
remote connection. the system board (see Chapter 9,
"Jumper and Switch Settings").
1206 - xx Dial Multifrequency Tone Test 2. Check the modem connection to
the 32 bit memory/modem
1206 - 17 Tone detection failed. interface board.
3. Replace the modem and retest.
1210 - xx Modem Direct Connect Test 4. Replace the 32 bit memory/modem
interface board and retest.
1210 - 01 Modem timed out waiting for 5. Replace the system board and
SYNC. retest.
1210 - 02 Modem timed out waiting for
response.
1210 - 03 Modem exceeded data block
retry limit.
1210 - 04 RCV exceeded carrier lost
limit.
1210 - 05 XMIT exceeded carrier lost
limit.
1210 - 06 Time out waiting for dial
tone.
1210 - 07 Dial number string too long.
1210 - 08 Modem timed out waiting for
remote response.