Compaq ProLiant 5500 - Integrated SCSI Controller

7-7
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Integrated SCSI Controller
The Compaq ProLiant 5500 and 5500R server has a Dual Channel Integrated
Wide-Ultra SCSI-3 controller integrated into the peripheral board. The two
outputs from this controller are designated SCSI Port 1 and SCSI Port 2 as
shown in the following figure.
4
5
2
3
1
Figure 7-4. Integrated SCSI controller outputs
1
Peripheral board
2
SCSI Port 1
3
SCSI Port 2
4
IDE signal cable
5
IDE power cable