Compaq ProLiant 5500 - Installing the IMD in the Tower Model

6-2
Integrated Management Display
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: G-CH06.DOC Last Saved On: 2/8/99 11:27 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Installing the IMD in the Tower
Model
The Integrated Management Display (IMD) feature is standard in rack-
mountable models of the Compaq ProLiant servers; this feature is optional in
tower models. The following information explains how to install the IMD in the
tower model.
1. Prepare the server for installation. See section "Preparing the Server"
located in Chapter 4.
2. Remove the IMD blank.
3. Install the Integrated Management Display.
Figure 6-1. Removing the Integrated Management Display blank