7-13
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Examples
This section contains example cabling scenarios covering the most common
applications. If your planned configuration does not match one of these
examples, use the SCSI Cable Matrices in Tables 7-1 and 7-2 and these
examples as a general guide.
Example 1:
Standard Configuration - Using
Integrated SCSI Port 1 for Hard Drives,
SCSI Port 2 for Removable Media Bay
The Compaq ProLiant 5500 and 5500R server ships standard in the simplex
mode, as shown in Figures 7-7 and 7-8. This configuration uses the integrated
SCSI controller to handle all seven SCSI drive slots. SCSI Port 2 can be
connected to the removable bay devices.
To Next Page
Loading...
