Compaq ProLiant 5500 - Page 119

7-12
Cabling for Wide-Ultra SCSI-3
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SCSI Cable Usage Matrix for Simplex Mode
Continued
Controller Hot-Plug SCSI Hard
Drives in Internal
Drive Cage
2/4 DAT Drive
4/8 DAT Drive
Internal TurboDAT
Autoloader
8X SCSI CD-ROM
4/16 TurboDAT
15/30 DLT Drive
35/70 DLT Drive
32 Bit Fast-Wide
SCSI-2
Controller/P and
Wide-Ultra
Controller/P
■
Use cable option
kit, part number
306585-B21.
■
Connect 19-inch
point - to - point
non-terminated
cable (199606-
007) from
optional
controller board
to SCSI Input 0 of
Simplex board.
■
Use cable option kit, part
number 306585-B21.
■
Connect 32-inch 3-
device terminated SCSI
cable (199616-012) from
optional controller board
to removable media bay
devices.
■
Use 50 to 68 pin adapter
(199618-001),if needed.
■
See note 1.
■
Use cable option
kit, part number
306585-B21.
■
Connect 32-inch
3-device
terminated SCSI
cable (199616-
012) from optional
controller board to
removable media
bay devices.
Smart-2 Array
Controller /P, /SL,
/DH and Smart
Array 3200
Controller
■
Use Cable option
kit, part number
306585-B21.
■
Connect 19-inch
point-to-point
non-terminated
SCSI cable
(199606-007)
from optional
controller board
to SCSI Input 0 of
Simplex board.
Tape Drives and CD-ROMs are
not supported using a SMART-
2 Array Controller.
Tape Drives and CD-
ROMs are
not supported
using a SMART-2 Array
Controller.
Note 1:
If additional 50 to 68 pin adapters are needed order Kit #212055-001.
Note 2:
The SCSI Port 2 Controller is connected to the SCSI Port 2 connector and external SCSI
connector. It is recommended that you use SCSI Port 2 controller for either internal or external drives,
not both.