5-1
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: F-CH05.DOC Last Saved On: 2/5/99 3:17 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Chapter 5
Server Configuration and
Utilities
Using SmartStart
and Support Software
SmartStart is the intelligent way to configure the server and to load the system
software, thereby achieving a well-integrated server to ensure maximum
dependability and supportability. To use the SmartStart and Support Software
CD, refer to the Server Setup and Management pack. The first time the server is
configured, the SmartStart program automatically creates a system partition and
installs the Compaq System Configuration Utility and other Compaq utilities in
that partition.
NOTE: Until you run the System Configuration program, an information
message indicating that you are running with a default configuration will occur
each time you boot the system.
To Next Page
Loading...
