5-2
Server Configuration and Utilities
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: F-CH05.DOC Last Saved On: 2/5/99 3:17 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
To install the SmartStart and Support Software CD:
1. With your computer turned on, locate the CD-ROM drive.
2. Open the CD-ROM tray by pressing the load/unload button.
Figure 5-1. Inserting a CD in the CD-ROM drive
3. Place the SmartStart and Support Software CD in the tray (label facing
up), handling the CD from the edges, not by the flat surfaces of the disc.
4. Close the tray by again pressing the load/unload button.
Upon closing the CD tray, the SmartStart installation sequence will begin
automatically.
To configure the system and load the operating system, refer to the SmartStart
documentation provided in the Server Setup and Management pack shipped
with your server.
To manage the system, refer to the Compaq Management CD provided in the
Server Setup and Management pack shipped with your server.
To Next Page
Loading...
