Compaq ProLiant 5500 - Integrated SCSI Port 1 for Removable Media Bay

7-15
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Figure 7-8. Example 1: Connection diagram
Example 2:
Using One Optional SMART-2 Controller for
Hard Drives, Integrated SCSI Port 1 for
Removable Media Bay
1. Remove the installed SCSI cable (199606-007) from Integrated SCSI
Port 1 and SCSI Input 0 of simplex board.
2. Install the 19-inch point-to-point non-terminated SCSI cable (199606-
007) supplied with the cable option kit (306585-B21) from the optional
SCSI board connector to the SCSI Input 0 connector of the simplex
board.