xii About This Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: A-FRNT.DOC Last Saved On: 2/8/99 11:33 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Any surface or area of the equipment marked with these
symbols indicates the presence of a hot surface or hot
component. If this surface is contacted, the potential for
injury exists.
WARNING: To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
WARNING: Power Supplies or Systems
marked with these symbols indicate the
equipment is supplied by multiple sources of
power.
WARNING: To reduce the risk of injury from
electrical shock, remove all power cords to
completely disconnect power from the system.
Rack Stability
WARNING: To reduce the risk of personal injury or damage to
the equipment, a minimum of two people MUST lift the server
into the rack. The rack-mountable server weighs in excess of
92 LB (41.8 kg.). If the unit is to be loaded above chest level, a
third person must assist in aligning the rails while the other two
support the unit.
To Next Page
