A-6
Federal Communications Commission Notice
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: J-APPA.DOC Last Saved On: 2/8/99 11:10 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Taiwanese Notice
Laser Devices
All Compaq systems equipped with a laser device comply with safety
standards, including International Electrotechnical Commission (IEC) 825.
With specific regard to the laser, the equipment complies with laser product
performance standards set by government agencies as a Class 1 laser product.
The product does not emit hazardous light; the beam is totally enclosed during
all modes of customer operation and maintenance.
Laser Safety Warnings
WARNING: To reduce the risk of exposure to hazardous radiation:
■
Do not try to open the laser device enclosure. There are no
user-serviceable components inside.
■
Do not operate controls, make adjustments, or perform
procedures to the laser device other than those specified
herein.
■
Allow only Compaq Authorized Service technicians to repair
the laser device.
Compliance with CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and
Drug Administration implemented regulations for laser products on August 2,
1976. These regulations apply to laser products manufactured from August 1,
1976. Compliance is mandatory for products marketed in the United States.
To Next Page
Loading...
