Compaq ProLiant 5500 - Supported Interfaces; Rom; Fans; Power Supply

1-4
Introduction
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: B-CH01.DOC Last Saved On: 2/8/99 10:44 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Supported Interfaces
■ VHDCI (Very High Density Cable Interconnect) knockouts
■ Serial (two connectors)
■ Video
■ Parallel
■ Keyboard
■ Mouse
■ 10/100 TX PCI Intel UTP Controller
■ VHDCI Wide Ultra2 SCSI ports on Wide Ultra2 SCSI models
ROM
■ Software upgradable firmware including diagnostics
■ ROMPaq Utility used to upgrade ROM
Fans
■ Standard: Two 120-mm fans
■ Optional: Two 120-mm redundant fans
Power Supply
■ Standard: One hot-plug power supply that runs at
750W(220V)/500W(110V)
■ Optional: One hot-plug redundant supply (RPS) that runs at
750W(220V)/500W(110V)