8-8
Wide Ultra2 SCSI Cabling
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: I-CH08.DOC Last Saved On: 2/5/99 4:06 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Standard Ultra2 SCSI Configuration
Compaq ProLiant 5500 and 5500R servers are shipped in a standard
configuration which connects all drives from the hard drive backplane board to
the Wide Ultra2 controller Port 1.
Ultra2 Backplane Board Connectors
In the Compaq ProLiant 5500 and 5500R server, the backplane board has one
SCSI input channel, designated SCSI Bus Input. This connector is shown in
Figure 8-5.
2 31
Figure 8-5. Backplane board connectors
➊ Backplane board power connector
➋ Removable media power connector
➌ SCSI Bus Input
To Next Page
Loading...
