Compaq ProLiant 5500 - Page 118

7-11
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SCSI Cable Usage Matrix for Simplex Mode
Continued
Controller Hot-Plug SCSI Hard
Drives in Internal
Drive Cage
2/4 DAT Drive
4/8 DAT Drive
Internal TurboDAT
Autoloader
8X SCSI CD-ROM
4/16 TurboDAT
15/30 DLT Drive
35/70 DLT Drive
Integrated
SCSI-Port 2
Controller
See Note 2
.
In Simplex mode, the
recommended use for
SCSI PORT 2 is for the
removable media bay
devices. If SCSI PORT
1 is unavailable for the
hard drives:
■
Connect 19-inch
point-to-point
non-terminated
SCSI cable
(199606-007)
from SCSI Port 2
to SCSI Input 0 of
Simplex board.
■
Connect the 22-inch
3-device terminated SCSI
cable (199616-010) from
SCSI Port 2 to the
removable media bay
devices.
■
Use 50 to 68 pin adapter
(199618-001) if needed.
■
See note 1.
■
Connect the 22-inch
3-device terminated
SCSI cable (199616-
010) from SCSI Port 2
to the removable media
bay devices.
Continued