7-10
Cabling for Wide-Ultra SCSI-3
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Table 7-3
SCSI Cable Usage Matrix for Simplex Mode
Controller Hot-Plug SCSI Hard
Drives in Internal
Drive Cage
2/4 DAT Drive
4/8 DAT Drive
Internal TurboDAT
Autoloader
8X SCSI CD-ROM
4/16 TurboDAT
15/30 DLT Drive
35/70 DLT Drive
Integrated
SCSI-Port 1
Controller
Shipping
configuration:
■
A 19-inch point-
to-point non-
terminated SCSI
cable (199606-
007) is
connected from
SCSI Port 1 to
SCSI Input 0 of
Simplex board.
In Simplex mode, the
recommended use for SCSI
Port 1 is for the hard drives. If
SCSI Port 2 is unavailable for
removable media bay devices:
■
Connect 22-inch 3-
device terminated SCSI
cable (199616-010) from
SCSI Port 1 to the
removable media bay
devices.
■
Use 50 to 68 pin adapter
(199618-001) if needed.
■
See note 1.
In Simplex mode, the
recommended use for SCSI
Port 1 is for the hard drives.
If SCSI Port 2 is unavailable
for removable media bay
devices:
■
Connect 22-inch 3-
device terminated SCSI
cable (199616-010)
from SCSI Port 1 to the
removable media bay
devices.
Continued
To Next Page
Loading...
