7-19
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SCSI Input 0 Channel
The SCSI Input 0 channel connects to SCSI hard drive slots 0 through 3, as
shown in Figure 7-12.
SCSI Input 1 Channel
The SCSI Input 1 channel connects to SCSI hard drive slots 4 through 7, as
shown in Figure 7-12. In this case, slots 4 through 7 become SCSI IDs 0
through 3, respectively, on the SCSI Input 1 channel. The SCSI Input 1 channel
can be routed to the removable media bay from the connector on the duplex
enabler board. You can use this for connecting to SCSI devices in the
removable media bay.
NOTE: When connecting from the duplex enabler board to SCSI devices in
the removable media bay, you must set the SCSI IDs for the devices in the
removable media bay to 4, 5, or 6.
To Next Page
Loading...
