3-10
Rack-Mount Server Installation
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: D-CH03.DOC Last Saved On: 2/8/99 10:49 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Figure 3-4. Removing the server rail from the bracket rail
2. Put the server rails to one side. You will attach them to the rack server
chassis later, in the section, "Attaching Server Rails.”
The next figure shows the separated bracket rail with its inner sliding piece and
the flat, one-piece server rail.
Figure 3-5. Separated bracket rail (top) and server rail
To Next Page
Loading...
