4-4
Installing Hardware Components
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: E-CH04.DOC Last Saved On: 2/12/99 12:18 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
4. Disconnect any other external equipment connected to the computer.
5. Loosen the two thumbscrews on the front of the unit.
6. Loosen the Torx T-15 screw on the front of the server.
7. Slide the side cover toward the rear of the unit about 1 inch (2.5 cm);
then remove the cover.
Figure 4-1. Removing the server cover
To Next Page
Loading...
