Compleo Cito 500 BM SAM - Page 77

Operation
2023-05 D111XXXXXX | 05 77
38
The charging system indicates the "Disconnect plug from vehicle to
end" state.
• The charging process can be stopped at the corresponding
charger interface. The plug must be disconnected from the
vehicle.
39
The charging system indicates the "CCS + Starting a new charging
process not possible!" state.
• The charger interface is not ready for operation. A charging
process cannot be started.
40
The charging system indicates the "CHA + Starting a new charging
process not possible!" state.
• The charger interface is not ready for operation. A charging
process cannot be started.
41
The charging system indicates the "Type 2 + Starting a new charging
process not possible!" state.
• The charger interface is not ready for operation. A charging
process cannot be started.
42
The charging system indicates the "Authorisation unsuccessful"
state.
• The authorisation process has not been successfully
completed. The charging process cannot be performed.
43
The charging system indicates the "Authorisation not possible with
this card" state.
• The authorisation process has not been successfully
completed. The charging process cannot be performed with
the corresponding RFID card or chip.
44
The charging system indicates the "CCS – Charged: + Charging
duration + Finished" state.
• The charging process has finished at the corresponding
charger interface. The charged capacity is displayed. The
charging duration is displayed.
45
The charging system indicates the "Type 2 + Remove a plug" state.
• A plug of the corresponding charger interface can be
removed.