DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM / CD-MNDT4500
Table of Contents Revision 2
xi
8.2.3 Ethernet (100BASE-TX) ........................................................................ 8–2
8.3 Access Methods ................................................................................ 8–3
8.3.1 Direct (Physical) Access ........................................................................ 8–3
8.3.2 Indirect (Virtual) Access ....................................................................... 8–3
8.4 Addresses ......................................................................................... 8–4
8.4.1 Physical Address ................................................................................... 8–4
8.4.2 Virtual Address ..................................................................................... 8–4
8.4.3 IP Address ............................................................................................. 8–5
8.5 Basic Protocol ................................................................................... 8–5
8.5.1 Transmission Mode .............................................................................. 8–5
8.5.2 Baud Rate ............................................................................................. 8–6
8.5.3 Asynchronous Character Format ......................................................... 8–6
8.5.4 Character Set ........................................................................................ 8–6
8.5.5 Response Timeout ............................................................................... 8–6
8.5.6 Bus Inactivity Requirement .................................................................. 8–6
8.6 Message Structure ............................................................................ 8–7
8.6.1 Start Character ..................................................................................... 8–7
8.6.2 Device Address ..................................................................................... 8–7
8.6.3 Commands/Queries ............................................................................. 8–7
8.6.4 Confirmation Response ........................................................................ 8–8
8.6.5 Error Response ..................................................................................... 8–8
8.6.6 End of Message .................................................................................... 8–8
8.6.6.1 Command Ending ........................................................................... 8–8
8.6.6.2 Response Ending ............................................................................ 8–8
8.7 Remote Operation – Commands/Queries .......................................... 8–9
8.7.1 Command/Query Quick References .................................................... 8–9
8.7.1.1 Utility Commands/Queries Quick Reference ................................. 8–9
8.7.1.2 Configuration Commands/Queries Quick Reference ................... 8–10
8.7.1.3 Redundancy Commands/Queries Quick Reference ..................... 8–10
8.7.1.4 Status Commands/Queries Quick Reference ............................... 8–10
8.7.1.5 Stored Alarm Queries Quick Reference ....................................... 8–11
8.7.2 Utility Commands/Queries ................................................................ 8–11
8.7.2.1 TIM (Time) .................................................................................... 8–11
8.7.2.2 DAT (Date) .................................................................................... 8–11
8.7.2.3 TPE (Time Protocol Enable) .......................................................... 8–12
To Next Page
Loading...
