DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM / CD-MNDT4500
Table of Contents Revision 2
xii
8.7.2.4 TPS (Time Protocol Server) .......................................................... 8–12
8.7.2.5 LRS (Local / Remote Status) ......................................................... 8–12
8.7.2.6 MAC (Media Access Control Address).......................................... 8–13
8.7.2.7 IPA (IP Address) ............................................................................ 8–13
8.7.2.8 IPG (IP Gateway) .......................................................................... 8–13
8.7.2.9 SPA (Set Physical Address)............................................................ 8–14
8.7.2.10 SBR (Set Baud Rate) ..................................................................... 8–14
8.7.2.11 CON (Set LCD Contrast) ................................................................ 8–14
8.7.2.12 LCD (Set LCD Brightness) .............................................................. 8–15
8.7.2.13 SSM (Screen Saver Mode) ............................................................ 8–15
8.7.2.14 SST (Screen Saver Timeout) ......................................................... 8–15
8.7.2.15 VFD (VFD Brightness) ................................................................... 8–16
8.7.2.16 SRO (Set Reference Oscillator Tuning) ......................................... 8–16
8.7.2.17 SSA (Converter Slope Adjustment) .............................................. 8–16
8.7.2.18 RET (Equipment Type) .................................................................. 8–17
8.7.2.19 PNM (Part Number) ..................................................................... 8–17
8.7.2.20 FRW (Legacy Firmware Information) ........................................... 8–17
8.7.2.21 FRM (Firmware Information) ....................................................... 8–18
8.7.2.22 IMG (Firmware Image) ................................................................. 8–18
8.7.2.23 AID (Application Identification) .................................................... 8–19
8.7.2.24 FRB (Force Reboot) ...................................................................... 8–19
8.7.3 Configuration Commands / Queries .................................................. 8–20
8.7.3.1 FRE (Frequency) ........................................................................... 8–20
8.7.3.2 IFF (IF Frequency) ......................................................................... 8–20
8.7.3.3 ATT (Attenuation) ......................................................................... 8–21
8.7.3.4 CLD (Cold Start) ............................................................................ 8–21
8.7.3.5 MUT (RF Mute)............................................................................. 8–21
8.7.3.6 CMM (Configure Mute Mode) ..................................................... 8–22
8.7.3.7 CRM (Redundancy Mute Mode) .................................................. 8–22
8.7.3.8 AFR (Auto Fault Recovery) ........................................................... 8–22
8.7.3.9 PGM (Program Pre-select) ........................................................... 8–23
8.7.3.10 DPS (Display All Pre-selects) ......................................................... 8–23
8.7.3.11 CLR (Clear Pre-select Configuration) ............................................ 8–24
8.7.3.12 SEL (Select Pre-select Configuration) ........................................... 8–24
8.7.4 Operating Modes ............................................................................... 8–24
8.7.4.1 RED (Redundant Mode) ............................................................... 8–24
8.7.4.2 ICT (Initialize Chain Command) .................................................... 8–25
8.7.4.3 SAM (Switching Automatic/Manual Mode) ................................. 8–25
8.7.4.4 FBU (Force Backup) ...................................................................... 8–26
To Next Page
Loading...
