Contex FLEX50i - Page 101

Maintenance 8-20
13. Close the lamp cover – Slide the cover to the left until it CLICKS shut. The cover must always be
closed before turning scanner power ON.
14. Test the replacement by turning power on to see if the lamp lights. The scanner panel will display an
error if the lamp is not inserted correctly or if the lamp cover is not completely closed.
15. Reset the part replacement counter that triggers the warning flag -
Press the arrow down button to reach Reset Lamp Cnt., press
Enter
and use the arrow down to
select Yes. Confirm with Enter.
16. Calibrate the scanner.
Press
Enter
to confirm reseting
the lamp part replacement counter
Reset Lamp Cnt.
> YES