Contex FLEX50i - Page 19

Configuration and Setup 3-7
Maintenance installed. Left click on the WIDEsystem scanner Icon and select Launch Scanner
Maintenance from the menu. Follow the instructions on your screen.
See the section ”Running the Scanner Maintenance Program” for detailed instructions.
7
Set localization Preferences
On the iJET Panel - Select Menu > Advanced > Options >… to set preferences for language,
paper series and media handling (loading).
See the section on options for ”Personalizing and localizing the system” for details.
8
Make Printer Setup settings on the scanner
You can setup for two printer types – a B&W printer and a color printer. After you setup your
printers, pressing the Color Copy button will send the output to your color printer and pressing the
B&W Copy button will send the output to your B&W printer. In this configuration, both printers are
on the network.
On the iJET Panel
Printer set up is described for Color Printer below. The same rules and method applies for B&W
printer setup.
Get the network id information for the printer(s) you want to use from your network administrator.
Select Menu > Advanced > Printer Setup > Color Printer to make settings.
Select Menu > Advanced > Printer Setup > Color Printer > Interface > LAN. Use the arrow
up/down buttons to enter the printer’s IP address.
Select the Printer Model setup method – Auto Configure, Printer List or Custom Setup and apply
the additional setting(s) attached to the Printer Model setup method you selected.
See the section on “Printer Setup on the Scanner” for more details.
9
Make Scanner Network Setup settings on the scanner
On the iJET Panel
Select the Menu > Advanced > Network Setup. You can use DHCP network setup if your network
supports it. Otherwise you need to enter the network address information manually. Contact your
network administrator for the correct address values. Select Menu > Advanced > Network Setup >
Share Scanner > Yes if you want to enable PCs on the network to use the scanner.
See the section on “Scanner on Network Setup” for details.
10
Prepare the Printer
Perform actions and settings on the printer device such as check that the right paper is loaded
and the printer is ON. See your printer’s documentation for help.
11
Create a system media type for your printers media (Closed Loop Calibration)
You must create a system media type profile in order to color match paper media, printer and
scanner before using the system. Identify the media type (Coated, Glossy, Semi-Glossy) you use
with the printer then perform closed loop calibration (3 steps).
On the iJET Panel
Select Menu > Advanced > Options > Closed Loop Cal.
Press Enter and then use the arrows up/down buttons to reach the right media type and Enter to
Menu
Menu
Menu
Menu