Control Techniques COMMANDER SE

Commander SE Advanced User Guide 91
Issue Number: 4
This bit is used to select one of two variables. Users wishing to make the change by external control should program a
terminal to control this bit.
*Units: Menu.Parameter
This parameter defines the parameter that the variable selector is to control. Only parameters which are not protected can be
setup as a destination. If a non valid parameter is programmed the output is not routed anywhere.
12.10 Variable select bit
Ú
0 or 1
Ö
0 RW Bit
12.11
Variable selector destination
Ú
0.00 ~ 21.51
Ö
0.00
*
RW Uni R P