2-74
1010PVNFM-3A
Section 2
l The current measured correction value is displayed (see below).
l Press <ENT> again to install this correction value which will now appear next to the
[HF] menu cell.
NOTE: The value shown in the [Automatic] pop-up prompt can not be changed and is
for user information only.
fx (drive) 29
N (burst length) 5
Ltn in 5.316
Vf max CU
>Automatic
Vs max m/s = 0.026
Vs min m/s 1355.00
Empty %
Samples/Cycle 29
HF >-0.026
Controlotron Dual Path 4SS10G
Site Setup Data
l If you decide not to use the [Automatic] selection, press any key other than <ENT> to
abort the operation.
fx (drive) 29
N (burst length) 5
Ltn in 5.316
Vf max CU
Adjustment
Vs max m/s >Automatic
Vs min m/s 1355.00
Empty %
Samples/Cycle 29
HF >-0.000
Controlotron Dual Path 4SS10G
Site Setup Data
To Next Page
Loading...
