Controlotron 1010PVN - Totalizer Controls

2-37
1010PVNFM-3A
Section 2
The LAPTOT command freezes the Totalizer screen
display. However, the flow computer will continue to
update its internal registers. The flow computer will
show the current total when you repeat the F1 -
Numeric 3 key sequence. When you activate
LAPTOT, an L precedes the TOTAL symbol (i.e.,
[LTOTAL]) on the LCD Screen.
Clears the Batch Sample totalizer register. See
Batch/Sample Tot.
CLEAR
LAPTOT
CLEAR
(Batch/Tot Register)
CLEAR Clears the Makeup Latch. See paragraph 2.7 The
Data Span/Set/CAL Menu and subparagraph 2.7.1
Span Data.
*Use the key as the “Lead-in command” for 4-Path Totalizer operations.
TOTALIZER CONTROLS (the “n” in <Fn> = channel number)*
(Makeup Latch)
(Totalizer snapshot)
(Totalizer Freeze)
Resetting the Totalizer registers clears all total data
accumulated during operation.
Note: In Dual Path mode, the Totalizer operates only on
the virtual system channel (Ch 3). Therefore in this case,
the CLEAR trigger would be <F3> <1>.
NOTOT
(also clears overflow)
F1
F1
F2
F3
F4
6
F1
F2
F3
F4
4
F1
F2
F3
F4
3
F1
F2
F3
F4
2
F1
F2
F3
F4
1
Invoking the NOTOT command disables the Total-
izer. Totalization will not resume until you repeat the
Fn and Numeric 2 key sequence. When you activate
NOTOT, an N precedes the TOTAL symbol (i.e.,
[NTOTAL]) on the LCD Screen.